1. Parts
  2. Fuel Systems

2000 Suzuki Intruder 1400 Parts

2000 Suzuki Intruder 1400
Front Tire:
110/90-19
Rear Tire:
170/80-15
Spark Plug:
DPR8EA-9
Battery:
YTX16-BS-1
Oil Filter:
KN-138
Select Your Ride: Go

Refine
Sort By:
Grid List
Dynojet Stage 1 Jet Kit
Dynojet
Stage 1 Jet Kit
$58.99 - $156.00
You save $18.99 (20%)
(32)
Dynojet Stage 1 Jet Kit Intended for motorcycles with a stock engine using the stock airbox, air filter and stock pipe. Stage 1 kits are fully adjustable to allow the use of a well designed afterma...
Cobra Jet Kit
Cobra
Jet Kit
$49.99 - $125.99
You save $8.96 (9%)
(16)
Cobra Jet Kit Designed by Dynojet for Cobra Carburetor recalibration kits tuned specifically for cruisers using Cobra Boulevard exhaust and stock or aftermarket air filter Provide improved ...
Moose Racing Fuel Line
Moose Racing Fuel Line This quality made fuel line will not harden or crack Fuel line is made of premium polyurethane Available in 1/4", 3/16", and 5/16" i.d. Fuel line available in 3-foot lengths ...
Motion Pro Premium 3 Ft. Fuel Line
Motion Pro
Premium 3 Ft. Fuel Line
$16.19 - $20.69
You save up to $2.30 (10%)
  • Black
  • Clear
  • Grey
(2)
Motion Pro Premium Fuel Line Stronger and more durable than vinyl fuel line Use with any type of gasoline Resists swelling and hardening Resistant to direct sunlight, hardening and/or cra...
Drag Specialties Black Braided Hose
Drag Specialties Black Braided Hose Hose features a black nylon braided covering Suitable for either gas or oil applications Available in various sizes and lengths 1/2" hose is for oil ...
Closeout up to 48% off
Motion Pro Y Connector 10-Pack
Motion Pro
Y Connector 10-Pack
$16.99 - $24.99
You save up to $23.00 (48%)
  • White
(1)
Closeout up to 48% off
Motion Pro Y Connector 10-Pack White steel resistant plastic (Acetal) Used to run two hoses into one May be used with hose clamps or O-clips Fuel-resistant Sold in packs of 10
Motion Pro Stepless Ear Clamps
Motion Pro
Stepless Ear Clamps
$7.19 - $7.65
You save $0.80 (10%)
(0)
Video
VIDEO     
Motion Pro Stepless Ear Clamps Fuel line fittings for your motorcycle fuel system.Small fits braided fuel line with 3/16" I.D. Large fits braided fuel line with 5/16" I.D.
Motion Pro T-Connector 10-Pack
Motion Pro
T-Connector 10-Pack
$20.69 - $50.39
You save $5.60 (10%)
  • White
(0)
Motion Pro T-Connector 10-Pack White steel resistant plastic (Acetal) Used to run two hoses into one May be used with hose clamps or O-clips Fuel-resistant Sold in packs of 10
K&L Float Needles
K&L
Float Needles
$31.99 - $38.99
You save $1.60 (4%)
(0)
K&L Float Needles Need a replacement needle for your carburetor...look no further K&L has what you need to rescue, rebuild, and/or refurbish you carburetor. **Note: Product varies depending on ...
Motion Pro Fuel Line Fittings Kit
Motion Pro
Fuel Line Fittings Kit
$413.10
You save $45.89 (10%)
(0)
Motion Pro Fuel Line Fittings Kit Contains the parts needed to service any fuel line routing Includes 40 assorted O-clips, 40 assorted Y-connectors, 40 assorted T-connectors, hose clamps and a pai...

Latest Reviews

Matt (Roaring Spring )

Fit
Quality
Installation
Recommend

Save the Headache - Spend for the PC5

I have this on my 2014 Yamaha Raider. Thought I would give it a try since it was a "little" cheaper than the PCV. It has the ability to put in multiple maps (up to 10 and if you have your bike tuned right, you should never need 10 different maps) it has the feel of the old power commander III but instead of buttons you have adjustment screws (very touchy and if you don't have it attached to a computer to see the change, you can end up on the wrong setting) and the adjustments are in 10% increases to low mid and high. Save yourself the headache and go with a PC5 which has the ability to add the other accessories and you can use your phone with now.

Austin (Midlothian )

Fit
Finish
Durability
Features
Cost Benefit

It works

I bought a couple for a Ninja 250. For this bike, the kit included the float bowl gasket, float needle, pilot screw, spring, o-ring, washer, and plug for the pilot screw. Component quality and fit is good. I was able to clean and rebuild the carbs to make the bike run.

Robert (So Cal )

Fit
Quality
Installation
Recommend

Ripped off!!

I just had this installed on my 2006 Electra Glide, today. Bike actually ran good before I had this installed, just wanted to increase performance and fuel/air ratio and gas mileage. Now, it runs like crap. I was worried I was even going to make it home without calling for a tow truck! Popping, sluggish response, hesitation, missing. This is B.S.! If it doesn't "Auto Tune in the next 96 hours, it's coming out and someone is refunding my money. I'll go back to where it was with just Screaming Eagle tuner. Had NO problems with S.E., tuner!

Nick (Council Bluffs )

Fit
Quality
Installation
Recommend

Unlock the Evo!

Combined this with the Cobra Power Flow intake and side shots and my little XL1200C is a beast. The V&H map was great out of the gate but I eventually went for the autotuning. Did my dial in over the course of about a week and applied the map a few times along the way. The second application led to some clunky performance until the engine got to peak operating temps. The final map, though, is outstanding. I don't have any objective measurements to go by but the grin on my face when I roll on the throttle heavily is at least twice as wide as when I had the stock intake/pipes/ECM mapping.

Eric (Russell )

Fit
Quality
Installation
Recommend

Its an ok FI unit

I have a 2006 Yamaha warrior stock except some crappy drag pipe exhaust a previous owner put on, and the AIS delete done. This thing fits easily and installs fast, I found the stock settings were so so at best, I had to back off the throttle tip in pot and run the unit at 2-2 and about 1/2 and the bike seems mostly happy I have endlessly adjusted it and my hesitation at WOT is much better but not gone, if I turn it up more it gets worse turn it down to 1 or zero worse 2-2 and 1/2 = best. I wish I had just ponied up and got a USBIII or V Power commander though instead of trying this. I may later on get a PWR Commander and will for sure be getting a V&H pro pipe for it this winter. I don't recommend this just get a Power Commander they are better.