robert (Avon )
So, if you order this tool for a Yamaha 450, be careful. This is NOT the correct part.
Jonathon (Anaslime )
It was a little hard to start it going in the right angle because the magnet kept moving it out of alignment. I had to put a socket on it to keep it straight while threading it in! 14 mm wrench versus the original 17 mm size to tighten it down. The smaller size does allow me to use a close end wrench vs the larger original size I could only use a Socket wrench. The gasket / washer is not the copper type it is stainless steel, not like the picture .
Rico (Buck Ridge )
I have a 2014 Harley Davidson Street Glide. This cap fit my bike perfectly. If it doesn't fit your bike, then sell it and buy a Street Glide.
Dean (Livonia )
A little tricky at first to figure out without instructions but after a little tinkering they installed almost flawlessly. Had to machine the oil pump input fitting to fit, hit the side of the pump casing when installing.
Robert (Cresco )
Great looking on the bike. Difficult to see oil level on it.
Mike (Richland Center )
Don't go by the photo. All you get are the O rings. I needed the gaskets so the rings will go on the wall until, if ever, I need them.