-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
Chris (Fort Worth, TX)
Didn't like it
I did not like it. Lube went everywhere, not worth it.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
Tom (Pekin, IL)
Nice try but ineffective
I've purchased two of these. One with the single tightening screw and one with the double screws. Great idea, but doesn't seal well enough to force the lube down the cable. Maybe it could go down a new cable, but mine are very clean and nothing came out the other end. Very well made, but doesn't deliver. Too bad, would have been a fantastic tool.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
Dan R. (Florence, OR)
cable luber
Worked just as described. Just take the time to get it on correctly.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
David (Pensacola, FL)
Not what it should be
Followed the simple instructions, not that you need them for this device. When you connect the can and spray, all the lube squirts out instead of going down the inside of the cable housing. Pretty much worthless.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
Larry (Fall River, WI)
Motion Pro Cable Luber
The luber works OK. Makes it a little easier to get lube into the cable bit it leaks a lot from not fitting well.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
Motobiker (Picayune, MS)
Not bad
Does the job. Takes a little while to get sufficient oil down the cable, but it does the job with minimal mess.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
jimmy (chicago, IL)
Simply effective
Even though you can try spraying lubricant down into your cable housing and "making a big mess",this tool is simple and effective, it makes using the lubricant's can tube much cleaner and easier to use and only using what you need.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
SavannahCat (Sylvania, GA)
Cable Luber
Worked as described. Be prepared with a lot of rags, it makes a quite a mess.
-
Fit
-
Finish
-
Durability
-
Features
-
Cost Benefit
bev (new milford, NJ)
eh
Didn't create a good seal around the cable. Maybe that’s my fault, but I had a hard time getting the lube to get in the cable tubing.
