Skip Navigation LinksScooter > Accessories > Tools > Hand Tools (32) > Motion Pro Cable Luber
Motion Pro
Cable Luber
$9.50 
Lowest Price Guarantee
Customer Rating:  


Item Availability status
In Stock - Usually leaves our warehouse same business day
All Motion Pro
All Motion Pro Tools
All Motorcycle Tools
Email a Friend
Product Description
  • Used to inject lubricant into cable housing
  • Clamps over housing and wire allowing an aerosol can to be connected
  • Once lube runs out the far end, the cable is lubricated
Click swatch to view color options
Related Items
Cable-Lube Motion Pro
Cable Lube
 $11.95
Customer Reviews
Average Rating -  Based on 12 Review(s)
Fit   4.0
Features   4.3

Finish   4.1
Cost Benefit   3.8

Durability   3.9
Overall   4.0
Latest Reviews
Fit   3.0
Finish   4.0
Durability   4.0
Features   4.0
Cost Benefit   5.0
Overall   4.0
Jim Dustin,  OK Leaks It seemed to me that the cable luber was good in theory, but after spending quite a bit of time trying to use it.....it seems that there is something lacking. I tried tightening the unit at tight as I could, but it still kept leaking spray everywhere when you tried to use it. I think I finally got one cable lubed pretty well. I think it might work better on fatter cables.
Fit   5.0
Finish   5.0
Durability   5.0
Features   5.0
Cost Benefit   4.0
Overall   4.8
Scott Larson Los Angeles,  CA Patience is the key This thing works great, providing you pay attention to what you're doing. The instructions are minimal but it's simple to figure out that the cable slips through the slot in the rubber gasket and then you clamp it down tight. Make sure the stopper on the cable itself is inside the luber gasket because that's the key to getting enough seal. At this point is where you have to be patient. Because the seal is not 100% airtight for one-size-fits-all reasons, you can't just hook up your bottle of lube and blindly spray it in at full blast. Doing that will leave you with the results some other reviewers complained about, that the lube goes everywhere but the cable. Take it slow with low, consistent pressure and the spill-out will be relatively minor with the majority going where it belongs, and soon enough your cable is working like new. About five minutes of work and an almost completely seized choke cable was operating smoothly.
Fit   3.0
Finish   4.0
Durability   3.0
Features   4.0
Cost Benefit   3.0
Overall   3.4
Kee Forsyth,  MT Motion Pro - Cable Luber A lot people don't know about using this tool, Here in Montana we use it to keep out water. So, you see that there is many uses for this little Gem. Try your favorite lube or whatever, The combos are unlimited...
Fit   4.0
Finish   4.0
Durability   4.0
Features   4.0
Cost Benefit   4.0
Overall   4.0
Jason Detroit,  MI A Worthwhile Buy The cable luber fit well and only required that I loosen the throttle/choke cables from their attaching points at the bars, not actually remove them. Then you just attach the luber, tighten it down, insert straw, wrap it with a shop towel and spray until you see lube coming out the other end. It was quick, easy and effective way to do the job, but a little messy.
Fit   5.0
Finish   4.0
Durability   4.0
Features   4.0
Cost Benefit   3.0
Overall   4.0
Liz Henderson,  NV Great tool for the right application I'm pleased with the tool overall but unfortunately my bikes cables are of a design incompatible with it. I was only able to use it lube the choke cable, though it did a great job of that and it took seconds. I end up using the tool at work to lube cables more than on my bike, but it's a great alternative to purchasing brand new cables when all you need is a little grease. Very easy to use.
Fit   4.0
Finish   4.0
Durability   3.0
Features   5.0
Cost Benefit   2.0
Overall   3.6
TJ Austin,  TX Almost a great product I've only used this on my clutch cable so far, but the experience was frustrating. Every time I sprayed the lube it seems like at least half would come out the (small diameter) cable-end. The housing end sealed ok, but required periodic adjustment to maintain. Took me about 30 minutes to lube just the clutch cable: spray, jiggle the cable until the lube that came out the top goes back in, check/re-tighten the housing end, repeat.
Fit   4.0
Finish   4.0
Durability   4.0
Features   5.0
Cost Benefit   4.0
Overall   4.2
Ollie Cox Lake View,  AL I was too late I let my cable go too long before using this product.
Fit   5.0
Finish   5.0
Durability   5.0
Features   5.0
Cost Benefit   5.0
Overall   5.0
Wing Hyde Park,  TN Cable Luber Definitely need to get one of these. Very easy to use. Another tool in the bike toolbox.
Fit   5.0
Finish   5.0
Durability   5.0
Features   5.0
Cost Benefit   5.0
Overall   5.0
bykrmom River Falls,  MT Motion Pro Cable Luber I liked the way this little tool works, and I have to say it works very well. I was helping a friend rejuvenate a bike that had been abused and had received very little care in 10 years. The clutch was so hard to pull, it took 2 hands! 15 minutes with this tool and a tiny amount of the Motion Pro Cable Lube and you can now pull it with one finger. VERY GOOD! A word of advice though: put directions in with it, so people who have never used one can save time figuring out how it works. I give this
Fit   4.0
Finish   4.0
Durability   4.0
Features   4.0
Cost Benefit   4.0
Overall   4.0
Scott River Edge,  MD Cable Luber Very good product, a little drip around the clamp but nothing a paper towel can't take care of.
Copyright 1998-2008 Motorcycle Superstore Inc. All rights reserved.






View categories by: Title |  Brand |  Product

View by: Popularity |  Our Choices |  All-Round Favorites Title