joe
newnan, GA
Motion Pro-Cable Luber
A must have. I hardly ever have to replace a cable. This makes it easy to keep them lubed properly.
Mark Woodcock
grand ledge, MI
Cable Luber
Unit works very well. It will lube most cables on a motorcycle
Chuck West
Santa Fe, NM
Motion Pro - Cable luber
The device doesn't fit on all my 1996 BMW R1100RS clutch cable, but it did fit the throttle cable. I haven't tried it on my Triumph Thruxton, yet.
chuck bordenave
Prescott Valley, AZ
Chuck Bordenave
Great product
Kenneth Haller
Puyallup, WA
Motion Prow cable luber
Bought with a can o motion Pro Cable Lube. Lubed the clutch cable you really have to be patient and work the cable back and forth to get it lubed, good thing is it didn’t leak as much as my old one, still a messy job.
Art Iserman
Ft Pierce, FL
Good Cable Luber
Was everything as it was described.
Gary Reynolds
Baltimore, MD
Cable Luber
Good for lubricating most cables, But not all sizes. This will serve me well. It saves taking the cable out and risking damage. I would recommend this.
Rob
Clinton Township, MI
Motion Pro Cable Lube Tool
Good product, not perfect but the best solution for getting cable lube into your cable. Also the Motion Pro cable lube is very slick and makes for a very smooth clutch cable action.
Rob C
Columbus, OH
The only way to go
Of all the ways you can try to get lubricants down through the cables you want to service, this is the only way to go. Used properly, it works with no mess or waste. Just go slow and don't try to jet the lube into the cable. Great invention.
Mike
Riverton, WY
Motion Pro - Cable Luber
The inside has a stepped-in-diameter rubber bushing inside and as long as you get the tool to clamp over the correct size step for your cable it works like a champ. You need to loosen the cable and get some slack also. A good handy device that works very well.
Jim
Dustin, OK
Leaks
It seemed to me that the cable luber was good in theory, but after spending quite a bit of time trying to use it.....it seems that there is something lacking. I tried tightening the unit at tight as I could, but it still kept leaking spray everywhere when you tried to use it. I think I finally got one cable lubed pretty well. I think it might work better on fatter cables.
Scott Larson
Los Angeles, CA
Patience is the key
This thing works great, providing you pay attention to what you're doing. The instructions are minimal but it's simple to figure out that the cable slips through the slot in the rubber gasket and then you clamp it down tight. Make sure the stopper on the cable itself is inside the luber gasket because that's the key to getting enough seal. At this point is where you have to be patient. Because the seal is not 100% airtight for one-size-fits-all reasons, you can't just hook up your bottle of lube and blindly spray it in at full blast. Doing that will leave you with the results some other reviewers complained about, that the lube goes everywhere but the cable. Take it slow with low, consistent pressure and the spill-out will be relatively minor with the majority going where it belongs, and soon enough your cable is working like new. About five minutes of work and an almost completely seized choke cable was operating smoothly.
Kee
Forsyth, MT
Motion Pro - Cable Luber
A lot people don't know about using this tool, Here in Montana we use it to keep out water. So, you see that there is many uses for this little Gem. Try your favorite lube or whatever, The combos are unlimited...
Jason
Detroit, MI
A Worthwhile Buy
The cable luber fit well and only required that I loosen the throttle/choke cables from their attaching points at the bars, not actually remove them. Then you just attach the luber, tighten it down, insert straw, wrap it with a shop towel and spray until you see lube coming out the other end. It was quick, easy and effective way to do the job, but a little messy.
Liz
Henderson, NV
Great tool for the right application
I'm pleased with the tool overall but unfortunately my bikes cables are of a design incompatible with it. I was only able to use it lube the choke cable, though it did a great job of that and it took seconds. I end up using the tool at work to lube cables more than on my bike, but it's a great alternative to purchasing brand new cables when all you need is a little grease. Very easy to use.
TJ
Austin, TX
Almost a great product
I've only used this on my clutch cable so far, but the experience was frustrating. Every time I sprayed the lube it seems like at least half would come out the (small diameter) cable-end. The housing end sealed ok, but required periodic adjustment to maintain. Took me about 30 minutes to lube just the clutch cable: spray, jiggle the cable until the lube that came out the top goes back in, check/re-tighten the housing end, repeat.
Ollie Cox
Lake View, AL
I was too late
I let my cable go too long before using this product.
Wing
Hyde Park, TN
Cable Luber
Definitely need to get one of these. Very easy to use. Another tool in the bike toolbox.
bykrmom
River Falls, MT
Motion Pro Cable Luber
I liked the way this little tool works, and I have to say it works very well. I was helping a friend rejuvenate a bike that had been abused and had received very little care in 10 years. The clutch was so hard to pull, it took 2 hands! 15 minutes with this tool and a tiny amount of the Motion Pro Cable Lube and you can now pull it with one finger. VERY GOOD! A word of advice though: put directions in with it, so people who have never used one can save time figuring out how it works. I give this
Scott
River Edge, MD
Cable Luber
Very good product, a little drip around the clamp but nothing a paper towel can't take care of.
Steve Caylor
Dallas, KS
Cable Luber
I installed all new cables to accommodate after market handlebars, so they were completely dry. I haven't used a cable luber before. It seemed to work pretty well on the clutch and break cables, but for some reason when I used it on the throttle push and pull cables, most of the lube came out the wrong side no matter how hard I tightened it. I'm going to have to take the bike to the dealer to lube these cables after all because the throttle occasionally sticks.
Scott Rendleman
Morton, IL
Review - Motion Pro Cable Luber
In typical Motion Pro fashion, the workmanship of this product is excellent. The cable luber is easy to use and did a pretty good job. It did drool a little around the cable, even when tightened down. Not having another brand or model to compare to, I'd say it did as good as expected. Price falls right in the middle of the range I see for this type of product.