Albert (North Canaan )
Should be a standard part on all motorcycles straight from the factory!!! Do your homework with a volt meter and you'll be able to go right to the tail light connector. find your live wire for the brake just by putting a sewing needle thru a wire , connect lead to wire and other lead to frame, hit the brake and you'll find the brake wire when the needle jumps to 12 volts. Be sure you are on DC volts NOT ohmes. Unwrap some of the tape insulation ,cut the wire, solder, srink wrap, re tape, ride safe, and safer!!!! Al
ahmed (queens )
They aren't very bright, my bulky stock ones were even better... if I didn't have turn signals on my mirrors I would have returned them. Mediocre brightness Disappointed!!
Gerry (Lawrence )
Super easy install and much brighter than stock. The smaller size and the look fits the bike well.
Dave (Martinsville )
Yes, hard to find in store but, I have the internet. Though they are indeed very bright I did not get any more longevity out of them then I did with a lesser priced bulb with the same particulars.
James (Cumby )
Easy to install and look decent on the bike but the bolts that holds them together pulled out of the bushings as I was installing them. If they can't hold up to that their is no way they can hold up at highway speeds. Will not be buying bikemaster products again.
Kyle T (Anoka )
I bought this for my 08 gsx-600r. The light fit perfectly in the housing, however none of the connectors matched, and with the signals inside the sides of the tail, you would need to get custom plastics if you didn't want two turn signals on the back. While I do not recommend this product for my bike, it was a quality piece of equipment that everyone else seems to thoroughly enjoy on different bikes.