Baron risers
-
Fit
-
Quality
-
Installation
-
Recommend
Christy -
January 25, 2013(Phoenix, AZ)
Bought this as a gift for my brother! Perfect and he loves them!
Great product
-
Fit
-
Quality
-
Installation
-
Recommend
Denny -
January 17, 2013(Jay, OK)
I have already reviewed these risers when I installed. Have ridden several hundred miles since installing and am very satisfied. Fit was almost as if made for a Valkyrie, very little modification. Finish is great as is the comfort of the arm/hand position. Stock cables & wiring are fine w/ no lengthening necessary. Were shipped and received from MC Superstore in just a few days.
1997 Honda Valkyrie
-
Fit
-
Quality
-
Installation
-
Recommend
Denny M -
December 11, 2012(Jay, OK)
Risers not listed for my bike but ordered anyway. Easy fit. Cut red ended bolts off by 7/8" and work pefect. Look great, fit great. Better hand/arm position.
Baron 4" risers
-
Fit
-
Quality
-
Installation
-
Recommend
Denny -
December 11, 2012(Jay, OK)
Not listed for Honda Valkyries but I took a chance and ordered a set from Motorcycle Super Store. Three different pairs of bolts were supplied and all I had to do was cut off 7/8" of the Red tipped bolts. Not that critical on the measurement, roughly 1/2 to 1" would work. Very sharp chrome finish and quality parts. I have checked numerous sites for risers for the Valkyrie and am very satisfied with these.
Installed on '07 Vulcan 900 Classic
-
Fit
-
Quality
-
Installation
-
Recommend
Moe -
July 26, 2012(Minot AFB, ND)
These risers are an awesome product. What I perceived to be a small change made a big difference on the road. Baron provides all the correct hardware and good installation instructions. The only thing you'll need to buy extra is red Loctite. Installation is easy. My cables are fairly tight when the bars are turned fully in either direction, but not tight enough to make me uncomfortable. Overall great product and I highly recommend them.
Kickback Risers
-
Fit
-
Quality
-
Installation
-
Recommend
Jerry -
July 09, 2012(Wiggins, MS)
The risers fit perfect on my 06 VTX 1300R. Did not have to reroute cables or wires or brake lines. I don't have to lean forward now. Thank You motorcycle-superstore.com
2009 Sportster XL1200L
-
Fit
-
Quality
-
Installation
-
Recommend
Eric -
May 31, 2012(Lexington, NC)
Very hard to install on my bike. Too much time spent moving cabling and electrical wiring. Also note you cannot use stock speedo/clamps when installing these risers. Had to relocate my speedo to a side mount using Joker bracket and P-clamp. Bottom line is you can use existing cabling/wiring but be prepared to move everything from factory routing for this type bike anyway.
Geat look as well as comfortable
-
Fit
-
Quality
-
Installation
-
Recommend
DJ F. -
May 31, 2012(Longmont, CO)
These gave me the reach I needed, fit was perfect. I had to relocate my speedo and tach but that was expected on my 2006 Harley Roadster 1200. I tried a set of drag kick back risers and they did not even compare to the quality and look of the Baron risers. They also give the motorcycle a custom look. I highly recommend these for anyone who is having to stretch to reach handle bars. Brake line was a little short but just unbolted the clamp and problem was gone and does not look out of place
all good
-
Fit
-
Quality
-
Installation
-
Recommend
robert -
April 13, 2012(ft lauderdale, FL)
all 100 % good
950 tourer
-
Fit
-
Quality
-
Installation
-
Recommend
david -
April 03, 2012(santa maria, CA)
i put these on a yamaha 950 tourer though it is not listed in the fitment. works fine, had to rerout cables and brake hose but all were ok. biggest pain was the clutch cable but it worked out finally. these come with 3 pairs of different length studs which is not mentioned. ride is really improved, i dont have the longest arms in the world so these did make a big difference. wish they would have hidden the bar clamping screws.
