April 11, 2013(Pinhook, IN)
This tool does what it's supposed to do. I would recommend it to anyone that owns a bike. This is a must-have for your toolbox.
April 02, 2013(Slaughters, KY)
The luber didn't come close to fitting the choke cable on Honda atv. After several tries and after reading many reviews I wrapped the luber & cable end with electrical tape and it did work. It was messy and a hassle to get the tape off. Good idea, but needs much improvement to fit different cable designs. It did not work very well, but I haven't found a better option!
October 15, 2012(Cadiz, KY)
This works ok. I got more lube on the ground than in the cables, but it did work. Maybe I did not use it correctly. Also, It would not fit over some of the cable ends with the bigger fittings on the end. You can also lube cables with a syringe or hypodermic needle.
Motion Pro cable luber
September 24, 2012(Richmond, VA)
Worked as advertised with only a small amount of leakage.More informative instructions would have been helpful.
I'd by again
September 19, 2012(Piedmont, CA)
I've lubed cables on three different makes of bikes, and it's performs as advertised.
Slight tweak needed
September 10, 2012(Herndon, VA)
AT first i thought like most that it was junk, and lube went everywhere. However, if you just put electrical tape (a few quick layers) over both the cable on the one end and the black cable sheath, then attach the device-it works fine. A very simple fix.
September 05, 2012(Winnipeg, MB)
Exactly as expected, shipped relatively fast.
Didn't like it
April 30, 2012(Fort Worth, TX)
I did not like it. Lube went everywhere, not worth it.
April 24, 2012(Kennewick, WA)
Works great. No issues.
Nice try but ineffective
January 30, 2012(Pekin, IL)
I've purchased two of these. One with the single tightening screw and one with the double screws. Great idea, but doesn't seal well enough to force the lube down the cable. Maybe it could go down a new cable, but mine are very clean and nothing came out the other end. Very well made, but doesn't deliver. Too bad, would have been a fantastic tool.