1. Cruiser Motorcycle
    2. Parts
    3. Hand Controls

    2000 Kawasaki Vulcan 800 Handlebar Risers

    2000 Kawasaki Vulcan 800
    Tire Size:
    Front: 80/90-21, Rear: 140/90-16
    Spark Plug:
    CR7E
    Battery:
    YTX14-BS
    Stock Chain/Belt:
    520x114
    Stock Gearing:
    Front: 17T, Rear: 42T
    Oil Filter:
    KN-303
    Select Your Ride:Go
    Refine
    Grid List
    1-5 of 5

    Latest Reviews

    Bryan (Lancaster, PA)

    Fit
    Quality
    Installation
    Recommend

    Quality Product / Great Look

    Installed Kickback Risers on my 2007 Honda 1300 VTX R with no problems. The quality and finish is outstanding. Places my bars at the perfect spot.

    Matthew (Elizabethtown, KY)

    Fit
    Quality
    Installation
    Recommend

    exactly what wanted

    The feel of these grips is awesome! The metal finish is very nice! There are no blemishes in the chrome polish and all the rubber is perfect- no air bubbles or any goofy mess. The only problem I had with installation was the super glue dried very, very, very fast! If you don't mark it, it will be wrong. It was a good thing I did because it took literally 10 seconds for it to set. Other than that everything else is absolutely perfect.

    Bob (Auburndale , FL)

    Fit
    Quality
    Installation
    Recommend

    Water Resistant GPS Pouch with Handlebar Mount

    I had to modify the product plus add tape to the handle bar to get it tight. It fits my TomTom just fine, my cable fits fine, it has a short peg tail connector so it is easy to un-plug. The only problem is you can't see it in the bright sun here in FL unless you pull over and get in the shade someplace and reroute or what ever you want to do and then zip it back up and off you go. I rode for 2 1/2 hours last night and it worked perfectly, easy to see and hear on my 2007 Ultra Glide.

    Bobby (Talbott, TN)

    Fit
    Quality
    Installation
    Recommend

    Black on Black ISO GRIPS 2002 Nomad

    Great product, easy to install, and looks great. The most difficult part of the installation was removing the old grip in the left. Throttle side was much easier than I expected. The left side fit so snugly that the glue was not necessary. Vibration was never a problem, but the larger, softer grip feels much more comfortable. I'd definitely recommend these.

    nomad (Covelo, CA)

    Fit
    Quality
    Installation
    Recommend

    All Balls neck bearings inferior

    After looking at bearing set I went with OEM bearings. Easier to install and better steel. All Ball bearings felt and looked cheaper and were manufactured from less quality steel. To return is not cost effective.

    Back to Top