1. Cruiser Motorcycle
  2. Parts
  3. Cables/Lines

1995 Harley-Davidson Electra Glide Ultra Classic - FLHTCUI Clutch Cables

1995 Harley-Davidson Electra Glide Ultra Classic - FLHTCUI
Oil Filter:
KN-170
Select Your Ride:Go

Narrow Your Results
Reset
Grid List
1-2 of 2
Drag Specialties Braided Clutch Cable Top-quality replacement braided clutch cables add a great look to any bike Feature a coil-wound stainless steel outer casing, tempered-steel inner wire and an i

Latest Reviews

Abdul (Detroit, MI)

Fit
Quality
Installation
Recommend

Installed on wrong bike

I installed this on a 2007 zzr 600. It works but has an extra bend. It probably fits fine on its intended motorcycle. Seems to be of excellent quality. Installation was standard.

Fred (Milford, CT)

Fit
Quality
Installation
Recommend

Works great

The only hard part was getting the old inner cable wire out of the old cable, which you re-use. It had frozen up and then broke up inside the cable. After I got it out the new wire went in fine with a little oil.

Ben (Arlington, TX)

Fit
Quality
Installation
Recommend

Didn't work out for me...

I didn't even have it for a month and the cable broke while riding at 75mph. The sharpest angle of the cable was not even a 45* bend. But the bad thing is that it broke beyond the bends, almost mid way up. Might have been a bad cable. Either way, it didn't work out for me.

Dillon (Phoenix, OR)

Fit
Finish
Durability
Features
Cost Benefit

Must work because I can still stop!

Changed OEM lines because they were starting to melt after 7 years of trackdays and racing. The install was easy to understand and the lines married up to the OEM master cylinder easy peasy!

Joey (Denham Springs, LA)

Fit
Finish
Durability
Features
Cost Benefit

Joke of a design

Ordered a set for my 2006 zx10-r and not only did I have to grind away at the cable housing just to make them fit inside the throttle housing. Where the cables attach to the throttle bodies Motion Pro decided to thread the ends with a larger diameter than can fit into the TB mounts. How hard is it to mimic the OEM design or even come close? All they had to do was make it smooth so it slides in nice and easy. These cables were garbage, don't waste your money because obviously MP didn't take the time to make sure their crap fit before they mass produced these things. If you're going to spend $60 go with another brand or OEM specifically.

Back to Top