Mike Taylor (Reedsport )
I have a yz250f and no mater where i mounted it the vibration was not enough to work it accurately. I had to send it back.
Matt (Fort Worth )
This was a direct replacement for my 01 R6 and has worked great so far. After 29,000 miles my original stator finally died and after a lot of research I chose Ricks vs OEM not only save a little $$$ but found out through other reviews that they are reliable. If you have the same bike and are curious regarding the harness and grommet they are all included and work great, no need to splice or install anything. The new stator went straight from the box in to the R6 and I was done in about 10 mins, I didn't even use a gasket, I just used the ultra black RTV gasket maker and it has worked flawlessly.
Bert (Murrieta )
All is good-put them in-it started-I am riding-it runs great
Bob (DuBois )
These plugs perform better than the CR7's that were installed in the bike at the factory. Smoother idle and better low RPM performance.
CARLOS (MIAMI )
I order it because it states equal to OEM and it is not at least for the YZ250F 2015, you have to shorten the cable length , cut the wires as the connector is different and it will not fit easily in the handlebar, price is good and it works tough.
Aki (Miami Beach )
I've only had it on the bike for little over a month now but seems to work well. It's a bit expensive in my opinion but does the job. The last one I had only lasted a year. Hope this one won't disappoint me like that one did. Then again, I only paid $30 bucks for it.