1. Cruiser Motorcycle
    2. Parts
    3. Lighting

    2001 Kawasaki Vulcan 800 Classic Load Equalizers/Converters

    2001 Kawasaki Vulcan 800 Classic
    Tire Size:
    Front: 130/90-16, Rear: 140/90-16
    Spark Plug:
    CR7E
    Battery:
    YTX14-BS
    Stock Chain/Belt:
    530x112
    Stock Gearing:
    Front: 17T, Rear: 42T
    Oil Filter:
    KN-303
    Select Your Ride:Go
    Refine
    Grid List
    1-2 of 2
    Kuryakyn
    Load Equalizers
    $17.99 - $18.99
    $15.29 - $16.14
    You save up to $2.85 (15%)
    (0)
    Kuryakyn Load EqualizersThese load equalizers work great in custom applications where OEM turn signals have been removed & replaced with low draw L.E.D. or small incandescent turn signals. Sold each

    Latest Reviews

    Sylvester (Carrollton, GA)

    Fit
    Quality
    Installation
    Recommend

    KNIGHT RIDER LIGHT BAR

    The Knight Riderz Light Bar is a great addition to any bike. I highly recommend it to everyone. Highly visible, people respond to the flashing. Easy installation. GREAT PIECE OF EQUIPMENT.

    James (Myrtle Beach, SC)

    Fit
    Finish
    Durability
    Features
    Cost Benefit

    BACK OFF BRAKE MODULATOR

    Good product, and easy to install. The hardest part was working with Harley wiring under the seat. Product is very effective and makes my brake light system much more noticeable when stopping. We bikers need all the extra safety around all the four wheel nuts today. I would highly recommend this product.

    Marc-Andre (Blainville, QC)

    Fit
    Quality
    Installation
    Recommend

    I like them

    As bright as stock, but I had to install a resistor in the wire to use them because my signals worked on a thermal relay and I didn't want to buy an electronic relay. Also, I had to install the OEM plugs because it didn't come with it... This installation was easy for me because I know how to solder electronics, but you should consider it before buying... also, check for your signal relay compatibility. I like them, they look good on the bike! I ride a Kawasaki Ninja 250R 2012.

    Rodger (Clearlake, CA)

    Fit
    Finish
    Durability
    Features
    Cost Benefit

    Almost bolt on.

    Finish was good, had to elongate stock mount holes in fender and use flat washers to mount bar on fender as threaded holes in bar did not match. I mounted license plate below tail light and used a die grinder to open up a slot on bottom inside of bar as the tail light I am using has a bottom lens license light. The end result is that this bar worked, just not quite bolt on.

    Lyn (Center Cross, VA)

    Fit
    Quality
    Installation
    Recommend

    Kuryakyn Panacea taillight

    Good product, easy installation, directions are a little confusing but not impossible. Very pleased overall!

    Back to Top