Travis Schroeder (myrtle beach )
Great little lights, nice fit, easy to wire. I like them so much I'm ordering another set and mounting them on my front end for added marker lights plus the ground effect style illumination from the white lights.
Jay (Fullerton )
Lights are very bright. The install was simple and I didn't drill anything. I just used double sided 3M tape on the back of the light and stuck it to the license plate - solid hold. I didn't drill, but did make a little hole in the plate itself so that the wire could be routed. I would most definitely buy again.
john (Clarkston )
I purchased these to clear up the rear end of my '04 Honda CBR1000RR. The lights themselves work great and are very bright; I've even had others comment on that fact. My only concern is with the relatively thin wires due to the low-voltage nature of LEDs...I shielded them with some aluminized heat-shield tape due to the proximity to my exhaust, and to also hopefully provide them more durability, as again they are quite thin. Finally, I made sure to zip-tie them up as tightly as I could to prevent movement that might break them. Again though, from a lighting perspective I think they're great!
Jeff (Portland )
This is a great price for something that would be somewhat easy to make but you don't have to since this fits perfectly. It's a generic fit with wide spacing for bolts to mount to the undertail of the bike. Angle of the plate once the mount is bolted on is good, and you can reverse the mount if you want the angle changed slightly from how you had it mounted before.
josh (leesburg )
I bought these tag lights like everyone does...for cop reasons. The wires are so short on these that I could not do anything at all with them. Would never buy these again.
cordell (santa cruz, ca )
This product was great until it snapped off. I have no idea how it broke off, (snapped at the shaft leading to the LP holder) but one day it was there the next it was gone.