1. Dirt Bike
  2. Parts
  3. Hand Controls

2010 Honda CRF250R Steering Stem Bearings

2010 Honda CRF250R
Tire Size:
Front: 80/100-21, Rear: 100/90-19
Spark Plug:
R0409B-8
Stock Chain/Belt:
520x116
Stock Gearing:
Front: 13T, Rear: 49T
Oil Filter:
KN-116
Select Your Ride:Go

Narrow Your Results
Reset
Grid List
1-3 of 3
All Balls
Steering Stem Bearing Kit
$39.99
$35.99
You save $4.00 (10%)
(21)
All Balls Steering Stem Bearing Kit All kits upgrade ball-type steering bearings to Heavy-Duty Tapered Bearings for higher torque load and better wear than ball style steering bearings Each
Yoshimura
Steering Stem Nut
$30.95
$26.31
You save $4.64 (15%)
(2)
Yoshimura Steering Stem Nut This trick looking nut comes pre-drilled so you can safety wire it on and not have to worry about it coming off or loosening up on the track. Features: CNC machined

Latest Reviews

neal (telluride, CO)

Fit
Quality
Installation
Recommend

Cycra for Flexx

Looks good and does what they should. Only surprise is a slight bending of bushing when I tightened the long bolt that goes thru the Flexx joint connection. Perhaps it has this cheesy plastic bushing to bend on purpose, helping it to adapt to the various sweep angles that Flexx bars come in? does not affect performance however.

Bill (Murfreesboro, TN)

Fit
Finish
Durability
Features
Cost Benefit

Great Grips!

These are excellent grips to use on most any bike. Softer than factory grips and absorb vibrations very well.

claus (ann arbor, MI)

Fit
Quality
Installation
Recommend

protaper for xt250

I had to move the clutch and brake handles to make them fit. Without moving them the plastic shield does not reach far enough over to cover the sides of my hand. It would be a nice product and easy install if the plastic shield would be wider. Not really a very good fit for my XT250.

brian (huntington, NY)

Fit
Quality
Installation
Recommend

definitely a good product....not the best fitting tho.

I bought the wrong size and Motorcycle Superstore fixed it for me pretty quickly. Had a new set within a week. I live in NY so it takes a week. If you have fatbars you need the 1-1/8" size. They are a pain to fit. They fit best if you modify the bar ends. I've seen people install them without, but they dont fit as well. The center reach clamps are clunky where they attach. Not as clean as they could be, but still a well made product. They just require some patience to install.

Dave D. (Montdale, PA)

Fit
Quality
Installation
Recommend

Nice fit

Nice, durable grips that take a beating. They feel really nice and go on great. Don't waste time trying to glue them on, just spray your bars with spray paint on the last 3" and the grips will slide right on and will dry super tight in about an hour.

Back to Top