1. ATV
    2. Parts
    3. Hand Controls

    2002 Bombardier DS650 Heated Grips

    2002 Bombardier DS650
    Oil Filter:
    KN-152
    Select Your Ride:Go
    Refine
    Grid List
    1-12 of 12
    Western Power Sports
    Heated Grip
    $43.95
    $39.99
    You save $3.96 (9%)
    (21)
    Western Power Sports Heated Grip Warms up to steady heat when engine is running Quality rubber is resistant to low temperatures and resists cracking Easy to use sealed controls R
    Closeout
    Moose Heated Grips 20 watts of heating power Increased rider comfort with even and consistent heat distribution from unique flex circuit technology Fits all 7/8" handlebars with no adhe
    Cycle Country Heated Grips Comfortable rubber grips are 5" long with a 7/8" inside diameter and 24" leads Fits nearly all ATV models Installs quickly and easily to your 12 volt battery
    Moose Racing No Adhesive Heated Grips Fits all 7/8" handlebars No adhesive required; pushes on and stays on Increased rider comfort with even and consistant heat distribution from unique
    Moose Racing Complete Winter Pack Plus Grips to be installed with WD-40 (sold separately). Apply WD-40 to the inside of the grip and a chemical reaction occurs with a special coating applied
    Moose Racing Complete Winter Pack Heaters wrap around your handle bars and stay on with adhesive that is already on the heater. Simply pull off protective cover, wrap around handle bar, and p
    SPI Electric Thumb Warmer Thumb throttle heating element 3 position switch HI-LO-OFF 4 watts of electricity No screw or holes for installation
    SPI Grip Heater Kit Grip Heater Kit from Sports Parts Inc Allows use of any desired grip design Warmer than comparable products Easy installation Similar design to OEMs Inc
    Moose Racing Hand Warmer Kit Effective at keeping hands warm Simple operation hi/low/off switch Works on all models EXCEPT Bombardier models **Note: For use on ATV or Snowmobile only.
    Moose Racing Thumb Warmer Kit Keeps thumb warm in cold weather Simple operation hi/low/off switch Installation is easy, just peel and press Works on all models **Note: All Pol

    Latest Reviews

    C. T. (ann arbor, MI)

    Fit
    Quality
    Installation
    Recommend

    not a good fit on xt 250

    Installation is relatively easy, but to install you have to move the clutch and brake levers, which makes them harder to grip. Or you install the brush guard without moving the levers and your hands are not very protected, because the guards are not reaching far enough over the handlebar. It would have been easy to engineer a better product by making the guards wider. Not a perfect product, it protects your hands somewhat. I would buy a different guard next time.

    Ken (North Vancouver, BC)

    Fit
    Finish
    Durability
    Features
    Cost Benefit

    ATV Heater Grips

    Works great, keeps hands warm. Only 2 small issues: 1. does not keep thumb warm, looking for a throttle warmer now 2. on high heat, the glue inside warms up and allows the grips to rotate. So they work, just the glue needs to be better at holding. I would buy again. As first issue is nothing ths product advertises and the second issues mentioned is minor

    Ken (North Vancouver, BC)

    Fit
    Quality
    Installation
    Recommend

    KOLPIN GEARTECTOR ATV MITTS

    Good job at keep the hands warm Issue is not with these mitts, but with mitts in general. Hard to access ATV controls while using them. 4x4 selector, Winch controls etc hard to access. IMO, these mitts are great for the ultra cold day. Hand warms best for the basic cold days

    Alex (Englewood, FL)

    Fit
    Finish
    Durability
    Features
    Cost Benefit

    works good, didnt fit at first

    Clamps worked great, only problem is the supplied bolts were too long for my DR650. I had to get bolts that were 5 threads shorter.

    Back to Top