Top Selling Parts for your 1996 Honda XR250R
I purchased this to replace a Pro Circuit Platinum pipe that had developed some serious cracking. Other than the lower mounting tab being a little short requiring the factory rubber mounting to be tweaked a bit to get the bolt holes to line up, it was a simple installation. Wasn't sure if pipe came with o-rings since right below product info is a link for pipe springs / o-ring kit. So I ordered one too but the pipe does come with o-rings.
Troy Lee Lucas Oil graphics kit
Love Troy Lee gear! This kit has transformed our bike beautifully. It looks like a completely different bike and is by far the best looking of all our friends bikes! Quality product and definitely recommend this kit not only for the product but for the professional conduct of this compnay!
Pro Circuit Linkage Arm
PC link lowered the seat height 7 mm. Link lowered center of gravity (dropped triple clamps 4 mm), and the ride improved even more. The plushness I had dialed in the stock shock, actually improved and the handling of course is even better and easier to predict. Fitment was perfect, and installation pretty easy. Added a little waterproof grease to needle bearings. The finish is beautiful and this link actually weighs less than the stock link by about 2 ounces.
HiFlo oil filter.
Tried this oil for the first time on my BMW R1200GSA in the 2014 season. Always used the BMW OE filters prior. The HiFlo filter performs the same as the BMW filter does- without a moment of concern. Fits my fluted filter wrench and the bike perfectly. Only difference between the OE and the HiFlo appears to be the price point. Ordered more for 2015/2016 seasons.
Graphics guy (Valley Center, KS)
The graphics looked to be old when I got them. The vinyl had shrunk away from the paper backing which left a 1/16 inch line of adhesive around the edge. This made dirt stick around the edge of the decal and it looked old before the install was even over. After some heat and scrubbing with alcohol around the edge I cleaned it up and they look good. Adhesive works really well. BRAAAP!
Acerbis Driller (Valley Center, KS)
Good looking plastics but the shrouds needed drilled out to fit. Old hardware and the new bolt kit I bought were both too big to fit through the plastics. After a little creative drilling, which I thought was ghetto for a brand new set of plastics, we were all back to good. The little spacer washers won't stay in if you go too big on your drilling so it is better to go a little less and heat up the plastic to make it fit and stay like the OEM hardware. But they did look nice once installed.